...the following steps : • Switch off the Local Unit and the Remote Unit , unplug the Video - Cable to the Remote Monitor ( Dualhead devices : BOTH Monitors ! ) • Open the Local Unit like described above • Unplug Jumper JP1 and plug it to Position JP3 ...

...No jumpers and / or switches are located on the Modem Splitter . See Figure 1 for typical applications . A 6 - ft . DB25 male / DB25 female extension cable and a serial AT adapter ( DB9 female / DB25 male ) are included with the TL073A - R3 and ...

...connect it to a hub / switch . Use a crossover cable to connect it to a PC’s Ethernet port . NOTE : If you connect the PC to the LES301A , make sure that the PC is in the same subnetwork as the LES301A . 3 . Connect the LES301A‘s serial port to a ...

...C e use use eq the Dev Switch approp K Power connect ensure CATx cables Please A Sy Co conne ACS2 Using DVI , the DVI , DVI : a install nois I STP Key Key The The For and VI - D the of VI - D C ( . 2 . 3 To To 4 . 3 . 7 . 2 . 5 . 6 . 1 . • • 2 2 • ...

...including sensors , switches , satellite antenna control systems , video and audio studio automation , security control systems , and other industrial automation systems . 4.1 Pull - Ups Nine or ten pin bussed resistor packs are installed to pro...

...Make sure the power is switched off . The module is not hot - swappable . It may cause electric shock or any possible damage to the switch if the power is not switched off . Turn off the power before installation . Step 2 : Unscrew the cover plates...

...and power and surge protection products to media converters and Ethernet switches all supported by free , live 24 / 7 Tech support available in 20 seconds or less . © Copyright 2010 . All rights reserved . 724 - 746 - 5500 | blackbox.com ® BLACK BO

...and power and surge protection products to media converters and Ethernet switches all supported by free , live 24 / 7 Tech support available in 20 seconds or less . © Copyright 2010 . All rights reserved . 724 - 746 - 5500 | blackbox.com ® BLACK BO

...IP - based matrix switching and video wall control . IP - based controller enables full control over the IP - based MediaCento IPX transmitters and receivers and turns the system into an IP - based matrix switch and video wall controller . • W...

...network . Extension and switching of 4K video and HD video , along with direct access to Virtual machines from all of our 4K and HD receivers ensures a future - proof system . Transmitters , receivers and Ethernet switches are available . – EMERALD ...